“NATRAJ” BRAND FULLY MICROPROCESS BASED SCREW TYPE FULLY
UTOMATIC PLASTIC INJECTION MOULDING MACHINE WITH ELE. MOTER
SCREW DRIVE HYDRAULIC MOTOR.
CONTROLLER WILL BE  “ ARICO “ brand  (Taiwan make ) FA type
Industrial pc (186) Based Injection moulding controller with digital I\O
16,7 +1 temp controller in built with 2 analog output, 4, analog input
LCD display 320 x  240 piccel. ( 88 x 119mm )

Linear scale for easy setting of stroke for clamping and Injection stroke
& also give Q.C. for the moulded component. (e.g. pack piece or fail piece
alarm and seprate counter for both with auto-shut down facility.

Hourly counter for one month.

Core pulling facility (digital output ) with multi selection ( e.g. core out
Before opening, after opening or on the limit setting. As same core in
Before closing, after closing or on the limit setting.

Robot interface, photo detector for the component dropped o.k.
As this are to be programme for which you had to note in your order.
This is only output signal the device will fit at extra cost.

Hydraulic ejector will be with multi stroke, hold and delay.

Injection is provided with five stage injection and three stage holding for
The best quality component. ( e.g. total 8 stage of pressure and flow digitally
Set from the LCD for the Injection.

Nozzel sealing fast start and at the end slow with high pressure selling.
( e.g. while the nozzle touch the runner bush of the mould it will touch slow
Speed with high pressure.

Mould memory will be 60 with LOAD, SAVE AND DELEATE option.

Mould safety has been provided in this machine.

4 stage closing with mould safety and 4 stage opening.

Air blow with open end or while opening option as standard feature.
 ( ONLY ELECTRIC)